The outside dimensions of the Taylor Made Low-Profile Boat Guide Wheel for 1-1/2" Diameter Dock Pipes part # 3691214 are 14" diameter x 6" wide. view full answer...
The mounting bracket on the Taylor Made Dock Wheel Bumper # 3691079 is constructed of a 2" x 2" section of angle iron. The bracket is 3/16" thick and is 4" long. view full answer...
I spoke with Taylor Made about the Taylor Made Roll-In Dock Wheel part # 3691224 and they informed me that the wheel is 7-3/4" thick. Therefore, this is roughly how much of the axle will sit inside the hub. I hope this helps but if not just let me know. view full answer...
The bracket for the Taylor Made Dock Wheel Bumper # 3691073 is 12" Long, 4" high and 4" deep.
The lower mounting holes are 3/4" up and in from the ends of the plate with 3" to the next set of holes.
The top 2 mounting holes are 2-1/4" from the corner edge with the 2 holes centered 7" apart. view full answer...
The measurement you're referring to for the Erickson Removable Motorcycle Wheel Chock # EM07506 is 8". This wheel chock has overall measurements of 11-3/4" long x 8-1/4" wide x 8-1/2" tall and will fit tires up to 6" wide. view full answer...
I spoke to my contact at Yakima and he informed me that when the tongue of the Yakima Rack and Roll Trailer # Y08107 is collapsed and store in the upright position it would be 74-1/2 inches tall.
Removing the coupler would not be an ideal solution for storing the trailer as it would also require removing the wiring for the trailer.
For kayak carriers I would recommend going with the Thule DockGrip part # TH895. This will store the kayaks facing up and would work well with your Hobie kayaks.... view full answer...
I spoke to my contact at Curt about the Curt Solid Steel 2" Hitch Bar part # D36 and they informed me that it does not have a weight rating because it is not in the finished form. The weight capacity will vary depending on the length and amount of gussets or reinforcements that are used.
If you need something with an exact weight rating you may want to look at the Draw-Tite Ball Mount part # 4285 which has a 12" long shank (center of hitch pin hole to center of ball hole), comes with... view full answer...